|
|
|
|
|
|
|
|
Page 15
Axles
|
Made in the USA from 1 piece forgings, these flanged axles are of a superior material, heat treat depth and design, which exceeds the strength and durability of stock axles. The induction hardened non-tapered shaft combined with a ductile flange allows for shortening or bolt pattern changes in the future. Each axle is made to order with your choice of a 5 on 4 1/2", 5 on 4 3/4" or 5 on 5" bolt pattern with 1/2" fine thread studs. Spline choices include 28, 31, 33 and 35 splines. Axle sets come complete with bearings installed and heavy duty bearing retainer plates. |
|
  |
|
 |
 |
| Choose from the following: | |
| Bolt Pattern: □ 5 Lugs on 4 1/2" □ 5 Lugs on 4 3/4" □ 5 Lugs on 5" |
|
| Studs: □ 1/2" Fine Thread □ Stock (Press in) □ Screw in 2" Long □ Screw in 3" Long □ 5/8" Coarse Thread (Press in) □ 5/8" Fine Thread (Press in) |
|
| Brake Kit □ Disc □ Drum Pilot Diameter (Center hole in drum or disc) ________inches Flange OD (ID of drum or hat) _______inches |
|
| Splines □ 28 □ 31 □ 33 □ 35 □ Mini Spool □ Full Spool □ Posi □ Locker □ Open Differential Brand of Spool or Differential ___________________________ |
|
| Housing End □ Small Bearing □ Big Bearing □ Big Bearing (Torino®) |
|
| Overall Axle Length □ Right (Passengers) Side _________inches □ Left (Drivers) Side _________inches |
|
©2003 Winters Performance Products, Inc. All Rights Reserved. Warranty disclaimer located on page 17. Contents may not be reproduced without written permission. Winters claims no responsibility for typographical errors.
